Pressure Washer Accessories
Click here for Trailers
We have a full line of accessories for your pressure washer,
from water recovery systems to floor cleaners to hose reels.
Click Here to download our new Accessories Brochure
Hydro Twister® Click Here for more Twister Info
ANT28 - 28" Surface Cleaner
ANTV5 - Hydro Vac Surface Cleaner
ANT4C - 4 in 1 Contractor Surface Cleaner
ANT21 - 20" Stainless Steel Surface Cleaner
The Hydro Twister® is a flat surface cleaner that connects to a pressure washer and uses two nozzles rotating at high RPM within an inch of ground. It will clean concrete at up to ten times faster than a standard wand, with more consistency and less operator fatigue. Simply connect to your power washer and move the Hydro Twister® over the surface and watch a clean path appear behind the unit.
Click here for more info about Hydro Tek Surface Cleaners.
Hose Reels
The Hydro Tek mounted Hose Reels provide convenient and quick storage of both discharge and inlet hoses for your power washer. These hose reels have the ability to swivel 180° allowing you to unroll the hose from the side or the back of the trailer. When you are ready to travel simply reel the hose on to the drum with the handle provided and set the lock pin and you're ready to go. Click here to learn more about our hose reels.
High Reach Wash Pole
Our new 20 foot High Reach Wash Pole offers additional control and rigidity not found with the standard telescopic or extendable wands. This High Reach Wash Pole uses your standard Hydro Tek (or ST1500) trigger gun so there is no need for you to have to shut down your pressure washer to switch to the High Reach Wash Pole. Simply insert your trigger gun in to the holder and connect the hose using the twist connect fitting and you are good to go. The Hydro Tek High Reach Wash Pole includes a comfort brace gun holder, full length jumper hose, three sections of pole (so you can easily adjust the height to match the needs of your job) and a shoulder strap. The pole is rated to 4500 psi and 250 degrees F. Click here for more info on the high reach wash pole.
Muck Scupper / Sludge Pump
 |
Turn your pressure washer into a sludge, slurry or water evacuation tool. Pressure energy from the spray of a pressure washer wand creates suction that pulls water, up to 87gpm, through a heavy wall discharge hose. The Hydro Tek muck scupper connects to existing ¼” pressure washer wand quick connect coupler, no other tools required. Part number: ANS04 or ANS55. Click here for additional information on the Muck Scupper.
|
Wet Sand Blasting Hopper & Assembly
When combined with your pressure washer or power washer the Wet Sand Blaster nozzle injects sand or soda (baking soda) in to the water stream to aid in blasting off paint, rust scale, or graffiti. It features a tungsten carbide head and a sand probe that will draw sand directly out of the bag. The 400 pound optional hopper can feed the blast media directly in to the hose.
Chemical Rack
The Hydro Tek Chemical Rack provides, quick, convenient and sturdy storage for two 5 gallon buckets of chemicals. The rack mounts to the front of Hydro Tek Pro Tow Wash ® trailers which allows you to use the chemicals with out having to move the buckets. Simply drop the Detergent Pick up hose in the bucket and you are good to go.
Heat Link
Heat Link hot water generators heat the water from your existing cold water pressure washer. They are Diesel fired and require a 120 volt power source. They can handle water flows up to 6 gallons per minute and pressures to 3500psi.
Click Here for HeatLink information.
CPHL4
